Does anyone know if this drawing is correct or have a dwg or dxf file I can have?

http://www.gatechlocost.com/wordpres...ust-flange.jpg

Thanks,

-Jarrod

 

you could always print it out full scale and go get yourself a gasket and match the two up to see how accurate it is. what you trying to do?

 

looks like he's trying to make his own header gasket but why?

 

need dxf file for laser so I can see what a turbo looks like next to that supa fly flange

Unless I pull mine apart, I don't have anything to measure against and I need to have these cut asap while the getting is good

Thanks in advance

 

This is the contraption I wish to put next to the head of my 22re...

 

uhh..that doesn't look like it'd bolt up to the head of my 22R (same head as 22RE)

the bolt holes on the bottom closest to the inside are too low i believe.

mine are level all the way across

 

Yea I see what you are saying. Some of the dimensions look a little funny.....and I am sure it was designed with metric measurements from toyota so the drawing dims may be off some.

 

Nevermind...it's right...I will have to register on pirate to thank the guy.

http://www.pirate4x4.com/forum/showthread.php?t=777197