Forgot your Password?
Meet The Staff
Announcements, Tips & Tricks, Site Feedback, Test Section, & Contact Us
Tips & Tricks
Post Your Tests Here
Tech Write-Ups (Staging Area & More Articles In The Wiki)
Staging Area For Tech Article Submissions
Maintenance & Repair
Off Road Enhancements
Toyota SUV & Truck Tech
Newbie Tech Section
General Vehicle Related Topics (Non Year Related)
General Electrical & Lighting Related Topics
Tires & Wheels
Pre 84 Trucks
84-85 Trucks & 4Runners
86-95 Trucks & 4Runners
95.5-2004 Tacomas & 96-2002 4Runners
03+ 4Runner/GX470, & 05+ Tacomas
Toyota RAV4 Forum
Early Land Cruisers
99+ Tundra, 00+ Sequoia, 98+ Land Cruiser/LX470
Prerunner & All 2WD Rigs
Looking For A Mechanic/Fabricator/Shop
Maintenance & Repair Archives
Off Road Tech, Fab Shop, Solid Axle Swaps, Tool Time, & Engine Swaps
The Fab Shop
Solid Axle Swaps, All Years
Engine Swap Talk
Trip Planning, Trail Reports, Land Usage, 4Wheeling 101, Camping Gear, Off-Road Gourmet, & More
Off Road Trip Planning, Expeditions, Trips, & Events
Trip-Trail Reports & Photos
Land Usage & Off Road Responsibility
Camping, Expedition, & Overlanding Gear
The Off-Road Gourmet
First Aid / General Medicine
Vehicle Audio & Home Entertainment
GPS & Communication
Off Topic, Wiki Discussions, Fraudulent Vehicle Listings, & Stolen Rigs
Off Topic Talk
Introductions & New Arrivals
Other Modes Of Tranportation
Other Makes Cars/Trucks
Low Range Off-Road
Diesel Conversion Specialists
Vendors Build-Ups (Build-Up Section)
Axles - Suspensions - Tires - Wheels
Engines - Transmissions
Vehicles - Trailers (Complete)
Vehicles - Parting Out
Misc Stuff (Vehicle Related)
Misc Stuff (Non Auto Related)
Buying & Selling Advice - Feeler/Gauging Interest
Hot Deals - Free Stuff - Craigslist
Seller - Buyer Ratings For Members
The Classifieds GraveYard
Toyota Aftermarket & OEM Parts Suppliers
YotaTech Knowledge Base
Tech Write-Up Archives
Tire Rim Calculator
Become a Vendor
Share Your Pictures with Our Community.
a word from our sponsor
The Meyer plow partially mounted
And believe it or not after replacing two drain plugs this thing still works.
Next stop was the usuals for a tune up.
Right after I made the purchase I ran to the closest gas station and filled up with some premium fuel.
Begin adding the firewall components back on. Thanks for looking! Justin
Outside of the firewall now in a coat of color offically ending the modifications needed for this swap...at least for now.
The spacing between the levers is wider so a new leather boot will have to compensate for this but the console itself will be able to be reused without modification.
Ohter than that, so far so good.
The heater core does sit back just a touch and the lower bracket off of the vertical runner was now crowding into it. A little trim and reweld to have it turn quicker was all it needed.
Dash crossmember installed after paint along with the wiring harness. A quick mock up of the lower plastics to see if the new slightly foward shift tower position is going to clear.
In primer after cleaning and neutralization. Shoot a little mat black paint next.
Dash subframe and pedal cluster assemblywhere left raw from new and have since flash rusted through the years. Won't be seen once its all back together but it just bugged me to put it all back together rusty so a muratic acid bath was first.
a word from our sponsor
Go to page
Terms of Service
© 2019 MH Sub I, LLC dba Internet Brands