Ebay SAS Beast
#1
Registered User
Thread Starter
Join Date: Nov 2003
Location: San Diego, CA
Posts: 604
Likes: 0
Received 0 Likes
on
0 Posts
Ebay SAS Beast
#6
Registered User
Join Date: Feb 2003
Location: Louisville, KY
Posts: 284
Likes: 0
Received 0 Likes
on
0 Posts
weird. The interior is immaculate though. I like where it says "HAS NOT HAD IT OFF ROAD" yeah right! If not, that's stupid. It might be a little too tall to do a lot of off roading but what's the point if you don't do anything with it?
Although I almost believe it... that thing is soooo clean!
Still probably overall a waste of money in all the crazy work put into it. The description on it is very vague also, I noticed.
Although I almost believe it... that thing is soooo clean!
Still probably overall a waste of money in all the crazy work put into it. The description on it is very vague also, I noticed.
#7
Contributing Member
Join Date: Jul 2002
Location: Orange County, CA
Posts: 1,132
Likes: 0
Received 0 Likes
on
0 Posts
i also find it rather weird he has no details about the lift and the obvious SAS! all it says it 14" of lift.
-Casey
-Casey
Last edited by casey; 03-16-2004 at 01:12 PM.
Trending Topics
#13
Registered User
Join Date: Jan 2003
Location: western Colorado
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
Body lift, blocks on rear axles, hard to tell, but it looks like Chevy axles without drop drag link, no crossover steering, mismatched tires, its not a 4Runner, its a Chevota POS
However, if the spring work was done well, it could make for a good start on an all around leaf sprung Runner, but you'd have to get it cheap so you could spend some $$ getting the body lift out, putting in good springs without blocks and getting some genuine Toyota back under it.
However, if the spring work was done well, it could make for a good start on an all around leaf sprung Runner, but you'd have to get it cheap so you could spend some $$ getting the body lift out, putting in good springs without blocks and getting some genuine Toyota back under it.
#14
Registered User
Join Date: Jan 2003
Location: El Paso, TX
Posts: 1,705
Likes: 0
Received 0 Likes
on
0 Posts
Looks like the stock 3.0 radiator in there. If you live somewhere where emissions are tested there is no way that engine is going to pass. It looks carburated and I don't see the obvious emissions stuff a 94 engine should have. The wheels sticking out could be cured with wheels with the backspacing set to tuck them in but you'll need massive fender flares and mud flaps in most places to drive it on the street.
Thread
Thread Starter
Forum
Replies
Last Post
kawazx636
The Classifieds GraveYard
34
10-06-2021 03:03 PM
Toys4parts
86-95 Trucks & 4Runners (Build-Up Section)
2
09-26-2015 01:56 PM