Ok

So I think I am going to do a body lift, either 1 inch or 1.5 inch that I hear exists.

Who makes them? how much and what needs to be changed?

For the 1 inch only the steering extension? what about 1.5?

I have done searches and read up on threads but still have questions.

Thanks

 

4Crawler Body Lift (Roger Brown)

I bought a 1.5" BL from him last month. His site shows what items are needed for each height BL. His charts were a bit confusing to me so I e-mailed him my questions and he answered them very promptly. All i got was the spacers, grade 8 hardware and a steering extension.

 

For a 1" body lift all you need is pucks and bolts. For more, you might want bumper brackets, steering extension, etc.

I got 1" body lifts...over that you need Roger Brown and all the other extras.

 

do you have a complete kit of everything I will need to install the kit? I want everything, all at once so I dont have to hunt for parts or have any problems..

thanks!

 

Yes, for a 1" body lift, UHMW 1" spacers and Grade 8 hardware
http://www.wabfab.org/products/bl/bl.htm

 

what about a steering extension...do i need one? do you make one?

 

Not to bump WabFab by any means, but if you're ok with pre-owned (as in approx 2 mos old), I am taking off my 4Crawler (Roger Brown) 1" BL this week as I want to put it back to stock and then alternatively go with a spacer lift. I ended up not needing the bumper relocation brackets, so those will not be included in the kit, but you'll get the standard grade hardware, 1" ultimate lift blocks, and steering shaft extension. New, this kit would run you $108 shipped (he charges $10 for s/h) Will sell it for $75 shipped in the U.S. LMK.

 

pm'd you...lets talk

 

body lift just arrived....very excited