Hello everyone im pretty new to all this but i have a 94 single cab 22re Toyota pickup that i put an elocker in from what i think was a 2001-2004 tacoma, and i would like to share how the wiring went and hopefully it will help others

I will be listing 2 ways to wire it up depending on what you are wanting
nice looking and Quick and Dirty

Parts that i used
16ft of 6wire trailer wire
6 pin plug water proof requires 7 but both grounds can just be connected together (i used 8 pin before i found this out)
DPDT Relay 8pin could probably find a better one but heres mine
Toyota Elocker switch

Using the old wiring cut the not needed end off and add your plug and color match the wiring i did

Making Wiring Harness
Green/Black = black
Green = Green
Green/Red = Red
Green/Yellow = Yellow
Blue/Yellow = Brown this is for the sensor it can be used for an indicator light
2 White/Black can be combined

Relay
5 and 4 power
1 black
8 yellow
12 red
9 green
White Ground
Brown to the ground pin of light if your adding it
Last two pins are ground and switch

Toyota Switch
Now the stock Toyota Switch only came with two wires
The black and green
There is a light in the switch that has no connection if you want to uses the light you can cut and unpin the clock wiring and use the pins and wires
I added Blue, Gray, and Purple
Blue and Gray are for the light inside the switch
Purple is another power out source if you want another exterior light when it is pressed in

Blue and Black can be combined
Gray is Ground
things get a bit fussy for me cuse it was the las thing i did, but i believe black and blue are power and green is power out (could be the other way)


Quick and Dirty way

Will need 5 amp fuse, same wiring, and plugs and an (on)-off-(on) switch
honestly the picture does wonders
white to ground
brown to ground side of external light






[img alt="this is the plug that plugs in to the Truck i cut it off and used the other side to the Elocker motor
"]https://cimg9.ibsrv.net/gimg/www.yotatech.com-vbulletin/1500x2000/img_e2412_1__1070b3898c3c8587c85969f34249ae287fc96 109.jpg[/img]
this is the plug that plugs in to the Truck i cut it off and used the other side to the Elocker motor
[img alt="(on)-off-(on) switch no relay required just 5amp fuse
"]https://cimg0.ibsrv.net/gimg/www.yotatech.com-vbulletin/2000x1504/img_2411_1__24cf4d76be504a00be72005e7f06633954ef54 37.jpg[/img]
(on)-off-(on) switch no relay required just 5amp fuse

stock Toyota Tacoma switch, needed with DPDT Relay and 5amp fuse (i used 10amp)

 

 

Thanks for sharing, it's super helpful for anyone doing this mod!