Designing my new rear suspension setup...
#41
Registered User
Thread Starter
Join Date: Dec 2002
Location: Deep Gap, NC
Posts: 4,697
Likes: 0
Received 0 Likes
on
0 Posts
Here's a couple of pics. I know I haven't touched the upper links yet, but I'm thinking about doing it in stages to test out all the possibilities. My question is if I could remove the panhard bar based on the angles of separation of my lower links:
And, for comparison sake, here's the stock setup using the same CG for an accurate comparison:
I thinking that I've gained 12 degrees less of oversteer, a 7" lower Roll Center (not good, right?), and a 13% increase in antisquat. What do you guys think?
Chris
And, for comparison sake, here's the stock setup using the same CG for an accurate comparison:
I thinking that I've gained 12 degrees less of oversteer, a 7" lower Roll Center (not good, right?), and a 13% increase in antisquat. What do you guys think?
Chris
#44
Registered User
Thread Starter
Join Date: Dec 2002
Location: Deep Gap, NC
Posts: 4,697
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SnoViking
it makes me think that i want to be an engineer when i grow up... so i could understand it alittle more
Chris
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
Yotadawgjr
95.5-2004 Tacomas & 96-2002 4Runners
10
08-23-2015 10:51 AM
coffey50
Offroad Tech
17
07-28-2015 10:55 AM
Vargntucson
95.5-2004 Tacomas & 96-2002 4Runners
0
07-04-2015 12:15 PM