what was the over all cost for raw material? less the por15 i know that stuff is pricy.

 

Just the steel would run you $100-$200. Depends on if you can find scraps and good deals.

 

Looks very sharp, you have to stop by so I can see it.

 

200 i can deal with, 300 even. 900 or better for an out o'the box type i have a bit of a hard time with, ya know?

 

I too was wondering if you had any drawings with dimensions and measurments? Also wondering if you had made up a material list. Love your design and work.

 

You are in luck. I have been selling the plans for this and the front bumper.

Here is the sale thread:
https://www.yotatech.com/forums/f109...runner-285949/

PM me with your email address, and I can send you some more information.

 

You do great work. When I was looking to build my front bumper I wanted to model it after yours but I got lazy and just bought the CBI kit for my 95. I really wished I had a third gen just for these bumpers. Are you going to do a swing arm at all for this?

 

Thanks. Yeah, I'll probably design a swing out tire carrier when I get a chance.

 

Dude! that rear bumper is fantastic. You do great work, any chance that this design will work for a 2nd generation 4 Runner? more specifically 1992?
you must have tons of patience.

 

Thanks. But sorry, 3rd gens only.

 

Guys, I'm selling the designs for this and other bumpers. See this thread:
https://www.yotatech.com/forums/f109...runner-285949/

PM me if you are interested.

Thanks.