This is my first post, so I'm somewhat of a newbie to these forums, but not a newbie to Yotas.

I just completed the deckplate mod and I revved up my engine when I was finished and my engine stalled. I put the deckplate in and no stall. Any explanations to as to why this happened?

 

give the ecu a reset?

clean the maf?

 

^^^ Ditto.

The ECU needs to relearn, pull the neg batt terminal for 1 minute and try it again.
I bet it won't stall with the deckplate out after that.

You should probably clean the MAF soon as well.

 

How do you clean the MAF???

I had the neg battery pulled while I was doing it. Should I still reset the ECU?

 

maf sensor is real easy to clean just take it out spray with electrical contact cleaner and let it dry for a few mins also double check all the wiring

 

Use brake cleaner on the MAF, works alot better.

MAF cleaning:
http://www.4x4wire.com/toyota/mainte...tenancep5.html

Once you pull the neg batt terminal, the ECU has been reset.

 

Thanks for the quick replies. Works great.

 

also welcome to yotatech and happy april fools