Who all is making these now? I am about ready to get rid of my OME coils and go back to my stock ones.

 

bump..........

 

I got 2.5 spacers from Cornfed.

 

yeah, i am either looking at those or the protech ones. how much are you going to sell your SAWs for?

 

hey guy,
saw that your gonna pull off the SAWs, and particular reason why? And do you wanna sell em' to me.
shoots,
aaron

 

Give Brian at ProTech a try. I ordered a set of rear spacers from him a few months back and had them in my hands two days later (CA to MD). Very cleanly machined, black anodized, and fit like a charm. I ordered my rears from him since his design 'cupped' the top of the rear coil, allowing the use of the stock rubber isolator cone. At the time, I was unsure of whether or not Cornfed was still using their original design.
I know you are looking for front spacers though

Andreas

 

i already have the revtek topout spacer and wanted to use those in my pack though, i am not sure if i can do that with the pro-tech spacers, otherwise i would have already ordered them!

 

I`m taking them off to replace the nitrogen valve on the passenger side. I may/may not change oil, depends on my time.
Also, more than likely I will sell them unless Frankenstrut 3 turns ugly.