Ummm this sounds stupid but how do you put a clutch in. I have my manual flywheel already on. I have my pilot bushing, clutch disk, TO barring, and pressure plate. I know to put the T/O barring on the forks inside the bellhousing. I know to put the pilot bushing inside flywheel. I also know how to put on the cluth disk and pressure plate. But is that all there is to it? Is it the T/O barring what stops the cluth disk?

 

Pick up a manual. It shall show you and tell you how to install one step by step

 

I did and it didnt give good instruction. Im just wounderin if i got it right

 

Throw out bearing stops the clutch disc from what?

You are using one of these, correct?

 

i just did this man...

tob is in the tranny on the fork that connects to your slace cylinder rod...

if you got hte pilot in and the fly wheel one then you put the clutch plate and then the prssure place and put that tool in and tigten..

then with the new tob on the fork raise the tranny back in.. i used a heavy dity ratchet strap connected to the frame under the tranny and a tranny jack...

FINALLY got to try out my welded rear...

doing a clutch is satisfying.. youll get there..

anymore questions p.m me