installed 4:56 factory diff in third member "problems please help"
Nov 1, 2010 | 09:37 PM
#1
Thread Starter
Registered User
Joined: Oct 2010
Posts: 6
Likes: 0
installed 4:56 factory diff in third member "problems please help"
I just installed 4:56 factory diff into 1st gen 8' third. Some of the nuts would only tighten so much and then would start spinning and when I spin the driveshaft yoke sometimes the wheel doesn't spin. no gear oil in it yet will that make a difference. I don't want to move on to the front till the rear is right. Thanks.
Nov 4, 2010 | 12:14 PM
#3
Registered User
Joined: Dec 2005
Posts: 2,024
Likes: 6
From: Souderton, PA
I just installed 4:56 factory diff into 1st gen 8' third. Some of the nuts would only tighten so much and then would start spinning and when I spin the driveshaft yoke sometimes the wheel doesn't spin. no gear oil in it yet will that make a difference. I don't want to move on to the front till the rear is right. Thanks.
Sometimes the wheel don't spin? Do you me one, or both?
Thread
Thread Starter
Forum
Replies
Last Post
skoti89
Offroad Tech
3
Jul 8, 2015 12:05 AM
FS[SouthEast]: 1st Gen 4Runner Slider Window, Driver Side
coryc85
Misc Stuff (Vehicle Related)
0
Jul 6, 2015 04:07 AM
