Newbie Tech Section Often asked technical questions can be asked here
Sponsored by:
Sponsored by: CARiD

First time rebuilding top end

Thread Tools
 
Search this Thread
 
Old Nov 18, 2010 | 12:04 PM
  #1  
ramosr's Avatar
Thread Starter
Registered User
 
Joined: Sep 2010
Posts: 2
Likes: 0
From: Honolulu Hawaii
Unhappy First time rebuilding top end

Hi new to yotatech! I just finished a top end rebuild on my 95 4runner 3vze due to a blown headgasket. Everything went smooth with re-installation following FSM and this forum. Got it fired up and idles fine but after driving it for ahwile RPM rpm starts dropping up and down and car starts losing power and starts surging. Stoped it on the side of the road and tapped the throttle position sensor then starts idling okay for awhile and repeats process. I checked for codes and the only code that came out was code 14. I had a co-worker also with a 95 runner try my coil and igniter to test it in his car. No problems? checked all test points from FSM dizzy, coil, igniter fuel pressure and injectors and all checked okay. I'm lost to this point!

Last edited by ramosr; Dec 14, 2010 at 06:49 PM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jennygirl
86-95 Trucks & 4Runners
11
Nov 17, 2015 11:24 AM
Jmiller1023
Pre 84 Trucks (Build-Up Section)
23
Aug 6, 2015 07:03 PM
red88toy
86-95 Trucks & 4Runners (Build-Up Section)
11
Aug 3, 2015 07:47 PM
infinityisfive
Other Makes Cars/Trucks
0
Jun 16, 2015 06:51 PM




All times are GMT -8. The time now is 06:52 PM.