jsnby

That's a sic looking rig....I want to do the same lift and tire combo to my front end. Thinking about rear leafs though....

i_rifiyou

sweet truck aw1090....question, how did you remove the bolt on the pan hard bar...passanger side???? please help cause i drop the drivers side, take the nut off the passanger side and can't slide the bolt out

AW1090

Thanks guys...

robg...I do have driveline issues, but am not to concerned with them right now. I plan on skinning the underbelly and once I do that then I'll worry about the driveline. I'm running stock links cause as the rear is compressed the tire will fit in the stock wheel well. If you make the links adjustable then you'll hit the rear fender at full compression. I plan on eventually doing a three link system.

i rifiyou....I haven't had any problems with getting that bolt out. Is there a ton of rust or what?...I'd crack the nut off with an impact then grab a hammer to knock the bolt out. Soak it in pb blaster to cut through any rust if there is any......thanks again guys!

i_rifiyou

what is pb blaster, where might i go to get this?????

DudeBud

penetrating lube, its at auto parts stores everywhere comes in a can

i_rifiyou

sounds good i will try

T4R_TRD507

Nice truck! you are running 33 or 35?

in the front you have IFS?

in rear you have OME 2863?

HighLux

Holy digging up old thread Batman!

Did you even look at the date?