Oh....I seeee!! A necro in our midst! *Teh*.....mm'scary!! Start callin' Abe "cold noodle mac'o'doodle"! Fiddle about....fiddle all about, Uncle Ernie?

 

well, your rear's firm... I mean form's rare this morn.

 

Well, the ol' horrorscope said I'd be feelin' some new creativity this week.

 

One day matthew's mother was cleaning his room, and in the closet she found a S & M magazine. Unsure of how to confront matthew, she hid the magazine until his father got home. She showed dad what she had found while she was cleaning. He looked at the S & M magazine and handed it back to her without a word.
She finally asked him, "Well, what should we do about this?"

He looked back at her hesitantly and said, "Well, I don't think you should spank matthew."

 

That was such a terrible day. I really needed that spanking, too.

 

LOL

 

Hey....don't laugh!!! I'm still seeking therapy over that experience.

 

what matthew's not saying is that the next day after coming home from school he walked in and found his parents with that mag opened to page 69, and acting it out.

 

...they were acting it out

 

oh I almost forgot... my dad was filming it.

 

Oh dear God....the nightmare comes flooding back to the forefront of my mind! WAAAAHHHHHHHH!

(What Kirk's not saying is that this particular film is in his basement where his "little hideaway" is.... and the VCR!)

 

BLASPHEMER!!!!

it's betamax.

 

OOHHHHH!!! 'scuse me! I forget.....yer from CALIFORNIA!!. Yeeeaaahhhh.....mhmmm.

 

I think we could take this thread and make a reality TV show out of it.
What do you all think?

 

Oh I'm sure we could

What would we call it though?

Alright, doing the main bearing today...

#1 - .002
#2 - .002

More coming later

 

Alright, I started trying to take off the 3rd main bearing. The one in the middle...I took off the bolt and I can barely wiggle it back and forth. I hit it with a mallet (rubber one) and I just can't get it...a screw driver won't work either. Is there a trick to this one??? I'm stumped

 

Any help?

 

are you talking about the bearing cap?

 

Yep....the thrustwasher has it stuck in there. Use a long pry bar on the edge, if you have one, and tap the bar with the hammer.

 

Yep