Hey guys, I'm back with more questions. I removed the stock carburetor and installed my new 32/36 weber. I messed up my redline adapter plate and ordered an adapter plate from transdapt http://www.jegs.com/i/Trans-Dapt/969...rentProductId=

now my carb sits too high to use any of the stock throttle cable linkage, the bracket sits too low and it seems like it also needs to move over a bit, from the firewall to the front of the engine. Is there an easier throttle linkage setup, a little more universal or do I have to have someone fabricate these pieces to fit my truck? Thx in advance

 

Looks like once again, I answered one of my own questions. I'll post some pics if anybody ran into the same problem I did. I justed used bigger steel spacers, longer bolts for the bracket and I used a couple washers to push the u bracket out a bit further to reach the j arm thing on the cable.

 

Haha always post pictures and an explanation of how you fixed it even tho nobody replied , that way if somebody searches for Weber throttle linkage this thread will have the pics and answers 👌

 

Copy that brother

 

Do you still have the truck to take pictures? I'm running into the same problem

 

 

where do you run the vacuum too that supplied in the kit? The lack of instructions with the kit is frustrating

 

any idea where I can get a cable for this setup?