#1 cylinder not firing
Jul 10, 2005 | 01:11 PM
#1
Thread Starter
Registered User
Joined: Jul 2005
Posts: 4
Likes: 0
#1 cylinder not firing
87 4runner 22re, Solid axle swap 220k........My engine has good compression, new plugs, wires, cap, and rotor but will sometimes run ruff. I pulled the plugs and the #1 is soaked w/ gas, the rest are fine. Any input can help Thanks
Last edited by dstep012; Jul 10, 2005 at 01:36 PM.
Jul 10, 2005 | 01:46 PM
#3
Thread Starter
Registered User
Joined: Jul 2005
Posts: 4
Likes: 0
Yes, the tune up did nothing and I replaced the #1 wire. The truck runs fine sometimes but without any signs it just starts running bad and I have to give it gas to start it. On another note how hard was that 2.7 swap?
Thread
Thread Starter
Forum
Replies
Last Post
