I am swapping springs in the rear of my 85 runner. Axle is the stock one, it looks to be 2.5 inches, is this correct? I want to flip my U-Bolts at the same time so just trying to get everything ready for it.

2.5 inch round U-bolts for this right?

 

Should be about right, measure and you can confirm. I have my old '85 axle u-bolts and flipped spring plates for sale if you are looking for a set.

 

Holy spring inversion

 

what is that (bolton?) lower shock mount roger?

 

x2!!!!!!!

was it fun carrying around spare leaf packs? Lol jk....

 

It is a bolt-on lower shock mount:
- http://www.4crawler.com/4x4/4R_suspe...shtml#R-Shocks

Also have some of those available.

 

No damage to the springs, Alcan's are tough, can't kill them

Need to turn my upper bump stop 90 degrees so that it does not fold over under compression like it is in the photo.

 

Thanks for the offer but I need them by tomorrow morning, as its my daily I dont want to be down for more than the one day.

I did measure but it always helps to be alittle more sure.

 

If you can't find anything local, can ship with next day delivery.

 

Oh so the bumpstop just folded over...

I get nervous when my springs negative at all. I finally put my bumpstops on the front so they hit and stop the upward travel right when the spring is flat.