major problem with new part
#1
major problem with new part
hey i been havein speratic engine problems dieing and suddenly cutting in and out on the freeway tried a few differant things someone told me to replace the ignition pick-up assembly that goes from my ignition connects to 2 wires that run into my distributor so i replaced it and tryed drivein it and it wouldnt start at the gas station and barley made it home without dieing ...did i do somethin wrong or could it be a bad part ..please help its my wife daily driver ....1980 toyota 4x4 20r
#6
air gap ?shoot i dunno i thought it was a no brainer .it just has 2 screws not slotted i didnt think there was much adjustment to it .i put thr old one bcack in .is the air gap between the new ignition deal i put in there and the metal part of the rotor ?(where the rotor has those little blades on it that hits the metal peice of the ignition pick up)because i noticed the new pick up i put in there looked like it had a bigger gap.how would you set that?
#8
Registered User
On your 20r engine it may be preset, another words remove and replace and your good to go. I put a pick up coil on a 86-87 22RE and you have to set the gap.
Thread
Thread Starter
Forum
Replies
Last Post
Avenged
95.5-2004 Tacomas & 96-2002 4Runners
4
07-09-2015 07:55 AM
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
07-06-2015 01:20 PM