YotaTech Forums
0 2025/02/20 17:07:41
0 2025/02/20 17:07:38
0 2025/02/20 02:19:46
0 2025/02/20 02:19:44
0 2025/02/19 17:18:51
0 2025/02/19 17:18:47
The old resistor
The old resistor
0 2025/02/16 04:35:36
A nice coating of peanut butter
A nice coating of peanut butter
0 2025/02/16 04:35:34
Pre treatment
Pre treatment
0 2025/02/16 04:35:31
0 2025/02/16 04:19:16
0 2025/02/16 04:19:14
0 2025/02/14 03:25:27
Discovered yet more rust under the ‘O’ in Toyota, cut it out and installed an additional patch panel.
Discovered yet more rust under the ‘O’ in Toyota, cut it out and installed an additional patch panel.
0 2025/02/13 17:18:00
Found a spot of rust just above the fuel filler door so I cut that out and installed a small patch panel.
Found a spot of rust just above the fuel filler door so I cut that out and installed a small patch panel.
0 2025/02/13 17:17:58
0 2025/02/13 17:17:56
Removing the fuel filler steel hose section was a bear. All three screws needed to be drilled out. I think they’ll get replaced with stainless Allen screws or hex bolts.
Removing the fuel filler steel hose section was a bear. All three screws needed to be drilled out. I think they’ll get replaced with stainless Allen screws or hex bolts.
0 2025/02/13 17:17:53
0 2025/02/10 17:23:52
0 2025/02/10 17:23:50
0 2025/02/10 17:23:47
0 2025/02/06 18:37:24
0 2025/02/06 18:37:22
0 2025/02/06 18:37:19
0 2025/02/06 18:37:16
0 2025/01/29 02:30:54
Fender wells repainted with some bed liner spray
Fender wells repainted with some bed liner spray
0 2025/01/29 02:30:52
After welding in a patch panel and some bondo
After welding in a patch panel and some bondo
0 2025/01/29 02:30:49
Before pic of the area
Before pic of the area
0 2025/01/29 02:30:46
0 2025/01/18 01:36:39
0 2025/01/18 01:36:37
0 2025/01/15 21:12:27
Torque rod installed
Torque rod installed
0 2025/01/15 21:12:24
Check out the wear on these two spring backed pieces that sit on either side of the knuckle arm ball inside the drag link. The same pieces on the pitman arm end show very little wear.
Check out the wear on these two spring backed pieces that sit on either side of the knuckle arm ball inside the drag link. The same pieces on the pitman arm end show very little wear.
0 2025/01/15 21:12:22
0 2025/01/15 21:05:35
0 2025/01/15 21:05:32
0 2025/01/15 21:05:29
Torque rod installed.
Torque rod installed.
0 2025/01/15 17:19:38
Small spring bump stops or pads. Not sure what they’re called.
Small spring bump stops or pads. Not sure what they’re called.
0 2025/01/15 17:19:34
0 2025/01/14 20:29:29
0 2025/01/14 20:29:27
0 2025/01/14 20:29:24