OK I have the stock gage in my 95 runner. Right now, it reads a little bit over half way, or it might be right in the center. is this ok, and what temp would this be. Also what temp should the 3.0 be at for normal?

 

mine is usually a little bit under the middle of the guage.

 

mine is also a little bit under the middle

 

bit under the middle ditto

 

same here just under the middle

 

Get an aftermarket gauge the stock one don't show ÅÅÅÅe.

 

Mine was always on the cooler side of the center mark....

 

About 190

 

mine runs little under halfway mark, it started runnin higher, but not overheating and i flushed the system and replaced the thermo..runnin under half no matter how hard i push it now.

 

just under the halfway mark now, and I have a small coolant leak.

 

..............left of center........

 

a wee bit on the cooler side of the half mark

 

just a small bit to the left of center as well

 

btw meant to also say I agree with suprathepeg, aftermarket >>> OEM

 

With my aftermarket gauge I get between 160-210 and the factory gauge reads just below center so the factory one is kinda poop.