Shaky 2nd Gen Hoods Solutions
#1
Shaky 2nd Gen Hoods Solutions
Does anyone else notice how flimsy the hood seems at highway speeds? The thing just shakes and does its own thing. Anyone do anything to solve this annoyance? I guess it is just nit picking, but getting asked if my hood was about to fly off was the last straw... Solutions?
#2
Originally Posted by da_bigg_wigg
Does anyone else notice how flimsy the hood seems at highway speeds? The thing just shakes and does its own thing. Anyone do anything to solve this annoyance? I guess it is just nit picking, but getting asked if my hood was about to fly off was the last straw... Solutions?
Have you checked where it's shaking from? Bolts, latch, that kind of thing?
#6
Maybe you have the shaky hood mod all the ricers are raving about. I hear its comon on sunflowers. ha
hope you get that fixed, I hate it when your wondering how long its going to take before the hood smashes in your windshield.
hope you get that fixed, I hate it when your wondering how long its going to take before the hood smashes in your windshield.
Trending Topics
#13
Separated from the reinfocements underneath is also a possibility, but I even have a hole in my hood and a fair amount of the bracing cut away to fit the 3.4 swap, and I still don't have any flimsiness of the hood.
Now the '89-95 fiberglass hood that someone threw on my '83 when the original got damaged...that one flops all over the place at 35 mph.
Now the '89-95 fiberglass hood that someone threw on my '83 when the original got damaged...that one flops all over the place at 35 mph.
#14
I had a horrible rattling at idle.Took all kinds of stuff off until I figured out the reinforcment separated from sheet metal on hood.Take off hood,spread some weatherstrip adhesive into the frame to metal contact areas,turn hood flat side down to ground and put some heavy stuff on it.Let it dry and you good to roll.
#16
I had a horrible rattling at idle.Took all kinds of stuff off until I figured out the reinforcment separated from sheet metal on hood.Take off hood,spread some weatherstrip adhesive into the frame to metal contact areas,turn hood flat side down to ground and put some heavy stuff on it.Let it dry and you good to roll.
Thread
Thread Starter
Forum
Replies
Last Post
FS[PacSouthWest]: Husky floor liners '90-95 4runner
rocket
Misc Stuff (Vehicle Related)
3
Jan 21, 2016 05:03 PM
vanion2
99+ Tundra, 00+ Sequoia, 98+ Land Cruiser/LX470
2
Jul 29, 2015 06:17 PM
Steezy96yota
86-95 Trucks & 4Runners (Build-Up Section)
1
Jul 6, 2015 10:00 AM






