Yep I finally rolled my truck. opps it was at low speed <5mph on the road. I was doing donuts in a parking lot and it just slowly flipped driver side first with a low cut halfdoor. im fine but I broke the new windshield dam. i would have been crushed but i just made a nice little rear cage and that kept the back of the cab up. Time for a cab swap this one was done anyways the wiring sucked and it had dents. i will get pictures soon. Here is some of it before.

 

 

If I ever saw a redneck's yard, this is it!

 

my friend just rolled his runner...

 

where is the damage... your side view mirrors are intact

 

Hey Neil,

Part that cab out bro or keep it for nuts and bolts Nothin' beats a truck sitting there to rob parts from.

Backyard looks worse than mine! I'm gonna show my wife your pics to get some slack

Thanks for sharing man, truck really doesn't look that bad.

 

I have a feeling that these are "before" pics.


I love the look of the early trucks - especially on some proper rubber. Let see the roll-over pics!

Andreas

 

 

Where's the "after" pics???

 

Neil, Were you born and raised in West Virginia before you moved to Washington? looks like some of the yards around here. Don't have to go far for spare parts.
Glad your alright, it could have been worse!, Mike

 

That sucks....but I can't wait to see the pictures.

 

ok so here are the pics. it took a while because i have to barow a camera.




one of the bed bob

 

I think this should be in the fab forum now.

 

here are the pics. it took so long because i had to barow a camera.




and one of the bobed bed

 

<5 mph and your cage collapsed at the A-pillar? - not to mention the butted tubing that separated behind the B pillar hoop (I hope those were cut after the fact).... WOW. What did you use for your tubing-wall thickness?

Glad you are OK.

 

Cebby, his cage doesn't go to the A pillar. As far as he says it only goes to just behind the seats which explains why the A's collapsed. I think??????

 

ya the cab cage only went to the seats. nothing moved i cut it so i could remove the cab. i was going to do an exo over the cab but didnt get it done in time. this was all made of sech 40 and i am quite pleased at how it held i didnt have any bracing in it yet.