How many quarts are everyone puttin in their 3.4 4x4 tacoma engine WITH oil filter change. Mine takes a little over 5.5 quarts. What does everyone else use? also it says on the fill cap SAE - 5w-30 oil....but i use 10w-30 oil...is this ok? I live in south CA so it dosent see much freezing weather... thanks!

p.s i use castrol non synthetic gtx oil at 148k miles the engine dosent drip a drop or consume anything noticably...

 

5.5 qts, 5-30 here. I think you could safely go down to 5-30.

 

i have a 2000 v6 4x4, and i use 5w-30 regular dino oil here in mid cal..

my rig usually takes about 6 quarts with oil change.

russell

 

96 runner sr5 0w30 amsoil series 2000, running just fine!!:

 

I use about 5.5 quarts with a filter change.

I doubt 10w30 will harm your engine, but 5w30 would be optimal. Might give you a slight boost in fuel economy too.

 

A tad over 5.5 qts w/filter change (when don't you change the filter when doing an oil change?!?!?!) on my '00 V6 3.4L.

 

I was stating that I always change the oil filter with a Toyota oil filter every oil change. Some people go 10K on the same oil filter...i wouldnt!

Anyone else use 10w-30 in Cali?

 

I put in 6 quarts, after the filter has filled up, the oil level is just below the full mark.

 

I use 5-30 but I go up to the snow a lot....but I have friends who are desert bunnies and some of them run 10w-30

 

I use 5W-30 in mine because that is what the manual says is preferred and will work for all climates. 10W-30 is recommended for temps above 0 degrees.

 

I use 0w-20 oil. It's recommended for toyota's. And I have a 99 tacoma 3.4L engine. And mine holds 6 qts.

 

Bumping a ten year old thread to add bad advice. Interesting.

 

Wrong wrong wrong

 

It's a Jeep thing, we wouldn't understand

 

Unless you can prove up your statement about Toyota's revised oil recommendation for the 5VZ-FE to 0W-20 with an factual official Toyota document, we will use the document linked below to disprove your statement with the following: "ILSAC GF–4 SAE 0W–20: This oil has even better fuel efficiency and cold starting performance than 5W–20. Initial application for 0W–20 is in the 2006 model year 2AZ–FE engine and will be used in new engines to be developed."

The TSB can be found here:
http://www.matrixowners.com/tsb/TS-EG018-06.pdf

 

Again, a 10 year old thread bump by a misinformed soul. I think the important thing is just change your oil every now and then

 

I think once in awhile is much better then now and then!!

 

K&N for life