My clutch quit working. Replace clutch master cylinder and slave cylinder. My slave cylinder rod is not in line with clutch arm. Any one know what this issue is caused from. Internal clutch issues maybe?
Thanks for any help.

 

Sounds like the clutch fork is not where it should be. How "out of line" is it?

 

Pretty steep angle. Close to an inch from where I think it should be. I've tried to push the arm up. It's pretty solid.

 

Post some pics up of it. If the clutch fork somehow got bent or broke you'll have to pull the trans to get to it.

 

I was afraid of that. Clutch was working fine. Lost pedal pressure. Replaced master and slave. Now still nothing. I'll put up some pics tomorrow. Thanks.

 

When you lost pressure on the clutch was your Clutch Master cylinder empty when you changed it out.

Was it low at All??

If not something broke on the fork Hard to say just what till it is apart

 

That's no fun, is this common on the manual 4runners?

 

I've got my truck in the shop. I'll let y'all know what my issue is.