Ok so remember my plans with the T i was mentioning a month or so ago? Well i was at the peak of the build and flipped it. I was waiting till i got 900 in the bank so i could still have money left over, to get tires. I had the rims rock and ready, the lift was in my truck and i was suppose to order the tires TODAY but friday night, i hit a bad corner and wrecked. Pretty much what happened was it was almost dusk where the sun was in the "˟˟˟˟˟ you, your not allowed to see" phase and of course it came through the trees and i was so blinded, all i saw were tree tops above and so i went to slow down to turn but i braked too hard, slid, fish tailed, over corrected, drove up a bank and flipped. I'm pissed. lol

On the good side, my brother wanted to sell his 96 tacoma to me so he could get a newer one (before i bought my truck/ he's in the marines, has money now) so i'm going to get his with the insurance money back and lift his like i planned to with mine. I'm doing the bulldog lift and found spindles for the front (3") http://www.doetsch-shocks.com/9.asp and i wanted to give the back an inch or so it's not too offset.

Here's the truck right now, 1/2 in coil spacers (leveling kit) up front with wheel spacers


My question, WHERE DO YOU GET THE FLIP KIT? The leaf springs in the back are below the axle and i cannot find anywhere that has the kit for it. Do you just flip them around or do you need a brace or what? i saw a ubolt thing on this site but i'm not sure if that's what i need http://www.toyteclifts.com/index.php...mart&Itemid=72


PLEASE help with the rear lift, if you can. i don't want stock height in the back