Accel 300+ IG box-->No spark after accel 300 install
Jan 12, 2012 | 07:53 PM
#1
Thread Starter
Registered User
Joined: Oct 2011
Posts: 130
Likes: 0
From: Springfield Oregon
Accel 300+ IG box-->No spark after accel 300 install
Ok so i installed a Accel 300+ and my truck wont start. I did a little searching but didn't find much. Do i need to keep the stock ignitor?
Jan 13, 2012 | 09:03 PM
#2
Thread Starter
Registered User
Joined: Oct 2011
Posts: 130
Likes: 0
From: Springfield Oregon
No spark after accel 300 install
So I installed my Accel 300+ IG box and was not getting spark from my coil. So i double checked everything and tryed it again and nothing. So i put my stock IG box back on and I'm getting nothing. I'm getting 11.25 volts from the green plug but only 7 volts from the power side of the coil. I have tryed a different coil and Ig from my friends 79 and still am not getting spark from the coil.
Dose anybody have an idea that might cause my no spark problem?
Dose anybody have an idea that might cause my no spark problem?
Thread
Thread Starter
Forum
Replies
Last Post
sandyota
84-85 Trucks & 4Runners
18
Feb 4, 2021 11:16 AM
Sandman
86-95 Trucks & 4Runners
8
Jul 14, 2015 12:36 PM
