hey all, so a few weeks ago im on way way to work, when outta no where I hear a terrible noise ( id prefer not to even try to describe it) and suddenly lose power, so I limp it to the side of the road where I pop the hood and notice 2 huge holes in my block, so obviously it was time for a rebuild. At first I had a teeny tiny broke high schooler budget, and wanted to get it done cheaply, but after getting my first report card, my mom decided I needed to do it the right way so the shopping begins, I had been looking at complete engines for a while with out any results, then I finally came across a newly machined block, score. So I now have a newly machined block, bored .60 over with new pistons and rods. Next comes the head, I took it to the shop and ended up with a brand new looking head. I topped it all off with a new clutch kit, new oil and water pumps, timing kit with steel guides and a new timing cover. So at this point the motor is just about done and will be ready to throw in on Sunday. On to the pics

 

Moved to General Vehicle section.

The Build-Up section is reserved for members to post a thread dedicated to the build-up of their rigs.

Fink

 

Didnt know you could go .60 over on a 22RE without cooling issues??

 

Nice work so far! I went to school at Utah State. Awesome place with a nice lineup of canyons to drive around in. It's grown a lot since I lived there...

 

ya you can go .60 over but a lot of people dont, I dont have to heavy of a right foot, and i keep up on maintenance, no problems so far. Yeah this area is beautiful with tons of different canyons and trails to hit