I am working on a 1995 Tacoma. I want to replace the front bearings. Since they are pressed in, do I need to take it to the dealer to have them pressed out and the new ones pressed in? If I can get access to a press, can I do it myself? Any tips or thoughts??

 

ADD or manual hubs?

Either way its going to be soooo much fun to change them out..... trust me.

I ended up taking mine to a machine shop, and they will never do those again.

 

That doesn't sound very encouraging. I assume by ADD you are talking about the hubs that don't have to be locked in manually. I am pretty green at this Toyota stuff. It sounds like I need to just suck it up and take it to the dealer.

 

any machine shop should be able to press them out and put new ones in just call around
"USE BLOCKS!!!"

 

Bout 40 tons of pressure to remove and install IIRC.......