Hi all!

I've been searching all morning thru "e-locker" threads, but haven't found any info on this.

Can you swap an axle, complete or select pieces, from some 3rd gen type Toy with factory elocker, into a 1st gen (88 specifically) 4runner?

I'm wondering if I could shop for something like a wrecked '99 4runner or similar and could i swap the whole rear axle and get a rear elocker set up relatively easy? What gearing would it come with?

What y'all think?

 

i am surprised that you have not found it...it has has been covered multiple times. . a lot of people say to convert your housing..make a notch or something..lots of pictures

I and found a post with these links:
http://www.pirate4x4.com/forum/showt...ker+front+axle
http://www.pirate4x4.com/forum/showthread.php?t=357137
http://www.pirate4x4.com/forum/showthread.php?t=212065
http://www.pirate4x4.com/forum/showthread.php?t=288708

I know there are some threads on YT that show this same stuff, these were the quickest ones I found...Pirate4x4, (you might know) is not exactly free of bad language so please take that into account..

hope it helps...

 

duh: google. that would require i take my nose out of yotatech for longer than a minute. ha!

i didn't get over to the pirate site, i don't go there much. (i should visit more.) thanx Robb!

anyone else who's done this swap, i welcome your input here!

anyone done a full swap of the whole axle from truck to truck??