Notices
86-95 Trucks & 4Runners 2nd/3rd gen pickups, and 1st/2nd gen 4Runners with IFS

Almost there...CEL 24 gone...New CEL 25 with details...

Thread Tools
 
Search this Thread
 
Old Aug 25, 2007 | 12:48 PM
  #1  
diverjeff200's Avatar
Thread Starter
Registered User
 
Joined: Nov 2003
Posts: 80
Likes: 0
From: Van Buren, Arkansas (GO HOGS GO)
Almost there...CEL 24 gone...New CEL 25 with details...

Hey everyone...

Son just got in from college having driven all week at college and a couple of hours on the highway. CEL came on and we pulled a Code 25.

Son says that at highway speed, vehicle runs good up to 70 mph. Son said vehicle begins to shudder from 70-75 mph with RPM's between 3000 & 3100.

Haven't checked the O2 sensor yet but will this weekend.

Could a stuck injector cause this kind of problem?

Thanks for any ideas or direction,

DJ
Reply
Old Aug 26, 2007 | 09:55 AM
  #2  
thook's Avatar
Registered User
 
Joined: Sep 2005
Posts: 8,656
Likes: 16
From: NW Ark on wooded ten acres...Ozarks at large!
Shudder? The motor does or the vehicle itself?
Reply
Old Aug 26, 2007 | 10:05 AM
  #3  
TNRabbit's Avatar
Contributing Member
 
Joined: Apr 2006
Posts: 4,787
Likes: 36
From: TENN Native Languishing in Virginia
under load or when you let off?
Reply
Old Aug 26, 2007 | 10:19 AM
  #4  
diverjeff200's Avatar
Thread Starter
Registered User
 
Joined: Nov 2003
Posts: 80
Likes: 0
From: Van Buren, Arkansas (GO HOGS GO)
Hey THOOK,

It is definately the engine. He described it more like a miss at high speed (70-75). I will also say that it idles a little rough and I do mean a little. Just feels like something just not right.

I still have questions about one injector. When I put the "boot" into the intake, and then the injector into the boot, the injector fit really tight. I put a little silicone grease on the boot to get it to slide in the intake. Used new o-rings when putting the injectors into rails. Also blew out the rails.

I am assuming an injector can have limited function. I ohmed them all before installation and all ohmed +/- 1 ohm of each other. I would think if the solonoid was going out I would have a lower resistance.

Am somewhat of a bulldog when trying to fix something like this. OCD can be a curse lol.

Safety & blue skies,

DJ
Reply
Old Aug 26, 2007 | 10:21 AM
  #5  
diverjeff200's Avatar
Thread Starter
Registered User
 
Joined: Nov 2003
Posts: 80
Likes: 0
From: Van Buren, Arkansas (GO HOGS GO)
UNder load.
Reply
Old Aug 26, 2007 | 10:26 AM
  #6  
thook's Avatar
Registered User
 
Joined: Sep 2005
Posts: 8,656
Likes: 16
From: NW Ark on wooded ten acres...Ozarks at large!
Did you ever fix the VAM issue?
Reply
Old Aug 26, 2007 | 11:05 AM
  #7  
diverjeff200's Avatar
Thread Starter
Registered User
 
Joined: Nov 2003
Posts: 80
Likes: 0
From: Van Buren, Arkansas (GO HOGS GO)
Yes, replaced the VAFM last week and haven't received the Code 24. Didn't really seem to make any difference in the way the vehicle ran. Funny thing about this whole thing. Last week it was Code 24 only (no CEL 25). Now, with a new VAFM, CEL 25. I actually had hair 8 weeks ago when this whole HG replacement thing started lol.

Jeff
Reply
Old Aug 26, 2007 | 11:18 AM
  #8  
thook's Avatar
Registered User
 
Joined: Sep 2005
Posts: 8,656
Likes: 16
From: NW Ark on wooded ten acres...Ozarks at large!
Yeah, I can definitely relate!

Okay, so have you checked your timing since you replaced the VAFM?
Reply
Old Aug 26, 2007 | 11:37 AM
  #9  
TNRabbit's Avatar
Contributing Member
 
Joined: Apr 2006
Posts: 4,787
Likes: 36
From: TENN Native Languishing in Virginia
have you cleared the codes & started over?
Reply
Old Aug 26, 2007 | 01:43 PM
  #10  
diverjeff200's Avatar
Thread Starter
Registered User
 
Joined: Nov 2003
Posts: 80
Likes: 0
From: Van Buren, Arkansas (GO HOGS GO)
Hey guys,

I haven't checked the timing yet but did clear the codes after replacing the VAFM. PUlled the EFI fuse and the neg cable just in case.

With the long weekend ahead I hope to check the timing and the injectors. If I had been thinking, I'd put the injector in question on the drivers side but noooo, it's on the passenger side lol.

Jeff
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Ronnyboy
86-95 Trucks & 4Runners
34
Feb 11, 2016 05:57 PM
Sam hain
95.5-2004 Tacomas & 96-2002 4Runners
19
Sep 30, 2015 08:25 AM
charlie_fong
General Vehicle Related Topics (Non Year Related)
0
Sep 27, 2015 10:06 PM
Draven023
Newbie Tech Section
3
Sep 26, 2015 12:41 PM
256mbaker
95.5-2004 Tacomas & 96-2002 4Runners
2
Jul 31, 2015 06:45 PM




All times are GMT -8. The time now is 05:52 AM.