44044s in the front. what should i put in the back
Jun 22, 2004 | 11:57 AM
#1
Thread Starter
Registered User
Joined: May 2004
Posts: 39
Likes: 0
44044s in the front. what should i put in the back
I was planning on putting rancho 44044's in the front and chevy 1/2 tons in the rear but the 44044s are a little over 5 inches of lift and the 1/2's are like 4inchs. but longer. i refuse to use blocks and i've already got 4 inch springs on now but they are stiff as boards. maybe all pro's 5 inchers that are long. any suggestions.-travis
Jun 24, 2004 | 03:18 PM
#2
Registered User
Joined: Jan 2004
Posts: 161
Likes: 0
From: Phoenix
Originally Posted by youngguns4x4
I was planning on putting rancho 44044's in the front and chevy 1/2 tons in the rear but the 44044s are a little over 5 inches of lift and the 1/2's are like 4inchs. but longer. i refuse to use blocks and i've already got 4 inch springs on now but they are stiff as boards. maybe all pro's 5 inchers that are long. any suggestions.-travis
Yonggun
I have rancho 44044s springs up front as well. I used Allpro's 4" kit for the back. After it settled it might be about an 1" lower than the front. If I did this again I would get the 5 1/2 allpro kit and pull one leaf out.
Greg
Thread
Thread Starter
Forum
Replies
Last Post
Jnkml
95.5-2004 Tacomas & 96-2002 4Runners
3
Jul 6, 2015 01:20 PM
Steezy96yota
86-95 Trucks & 4Runners (Build-Up Section)
1
Jul 6, 2015 10:00 AM
