2002 Tundra V6 IAT Mod Wiring Help
Jul 14, 2004 | 08:12 PM
#1
Thread Starter
Registered User
Joined: Jul 2004
Posts: 2
Likes: 0
From: Miami
2002 Tundra V6 IAT Mod Wiring Help
I purchased an IAT sensor mod, but I am not sure how to install this on the five wire connector at the plug. It calls for the 12v wire and the wire that has the ohm reading between 600-5000 ohms. Obviously it was the not the red and black as the common installation says. Please help with the correct wires.
Jul 15, 2004 | 01:42 PM
#2
Registered User
Joined: Jul 2003
Posts: 89
Likes: 0
Originally Posted by 1963ragtop
I purchased an IAT sensor mod, but I am not sure how to install this on the five wire connector at the plug. It calls for the 12v wire and the wire that has the ohm reading between 600-5000 ohms. Obviously it was the not the red and black as the common installation says. Please help with the correct wires.
Sorry but I have to ask, what is an IAT?
Jul 15, 2004 | 03:28 PM
#3
Thread Starter
Registered User
Joined: Jul 2004
Posts: 2
Likes: 0
From: Miami
IAT Sensor
This is the sensor located on the air intake that regulates the ECU information. The chip bypasses the sensor to keep the fuel flowin and the engine running as if it were cold. 
I am tryin desperately to give more pep to the v6. I have installed an K&N intake, throttle body extension, but more power is requested for little cash.
I am tryin desperately to give more pep to the v6. I have installed an K&N intake, throttle body extension, but more power is requested for little cash.
Last edited by 1963ragtop; Jul 15, 2004 at 03:34 PM.
Thread
Thread Starter
Forum
Replies
Last Post
he's gone
95.5-2004 Tacomas & 96-2002 4Runners
7
Dec 3, 2019 07:08 AM
justdifferentials
Vendors Build-Ups (Build-Up Section)
14
Jun 11, 2017 08:36 PM
anniesball
95.5-2004 Tacomas & 96-2002 4Runners
2
Jul 30, 2015 12:14 PM
