Toyota Rear Full Floating Axle Flanges From Ruffstuff!
#1
FormerVendor
Thread Starter
Join Date: Sep 2006
Location: Sacramento, CA
Posts: 1,445
Likes: 0
Received 0 Likes
on
0 Posts
Toyota Rear Full Floating Axle Flanges From Ruffstuff!
I made these because another vender did not offer them to the public and we needed them for our axle builds and many requests' to buy them outright. I tried to buy them from him but his price was simply too high. Since we ordered material the other vender has began selling them to the public. This is a repost to clean it up.
So here are the flanges that can turn your rear axle into a Full Floater and they are from Ruffstuff!
This is a weld on Axle Flange to mount Front Toyota Mini, Fj40, or FJ60 spindles to the rear axle. The caliper bosses are made to use the IFS Truck ('86-'95) calipers and FJ40 or FJ60 rotors.
These are 1" thick and made from 44W Plate & cutout for the 3.5" axle tube used our Axle Housings. We will release a 3.25" & 3" version in a couple of weeks. These are $195 a pair
So here are the flanges that can turn your rear axle into a Full Floater and they are from Ruffstuff!
This is a weld on Axle Flange to mount Front Toyota Mini, Fj40, or FJ60 spindles to the rear axle. The caliper bosses are made to use the IFS Truck ('86-'95) calipers and FJ40 or FJ60 rotors.
These are 1" thick and made from 44W Plate & cutout for the 3.5" axle tube used our Axle Housings. We will release a 3.25" & 3" version in a couple of weeks. These are $195 a pair
#5
Registered User
Dan,
I read on a thread some where that you were going to be making these bolt on also(they would use the bearing cup mount.
I need to get a set of these, do you sell them without the disc bracket, or with the disc bracket unwelded, so i can weld it myself?
also, what is the disc brake hole spacing? I have a set of Supra brakes to go on these.
Thanks
I read on a thread some where that you were going to be making these bolt on also(they would use the bearing cup mount.
I need to get a set of these, do you sell them without the disc bracket, or with the disc bracket unwelded, so i can weld it myself?
also, what is the disc brake hole spacing? I have a set of Supra brakes to go on these.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
6th Gear
84-85 Trucks & 4Runners (Build-Up Section)
19
12-10-2019 07:31 AM
cchinny
General Electrical & Lighting Related Topics
6
06-25-2015 08:11 PM