Hey guys, I have a dilema. Recently i purchased a TRD 2nd gen supercharger off e-bay. When it arrived, all it included was a boost gauge and the supercharger itself; no hardware whatsoever with the exception of one very long bolt. The seller isn't being as cooperative as i would like and i would send it back to him to get my cash back but i dont think i'm going to find another s/c for $1200. My question is where can i find a fit kit to install this on my 2002 taco 4x4 (5vzfe)? I've tried calling my local Toyota dealership only to find out that Toyota no longer produces the kit.....No bueno..I have discovered that trdparts4u has some of the essential parts like the tensioner assembly and the one way valve, but the rest I'll have to hunt down like the CARB EO sticker and various other bits like vaccum lines, the cut out template, the throttle cable bracket, ect. To say the least, this endeavor has gotten tireing and I haven't even installed the s/c yet! Any help is much appreciated, thanks folks!

 

Here's a link to the supercharger instructions. A page or two in has a list of parts that may be helpful.

http://www.customtacos.com/tech/file...percharger.pdf

 

So I've gathered some parts together and have discovered that I can't just buy the CARB EO sticker from Toyota......good grief. So now I'm stuck. All of the other parts I can get; its that damn sticker I can't find. Any suggestions?

 

I have the same problem. I also need the instruction manual for a 2002. I understand the vacuum lines are different.

 

There are several vaccum line configurations at the end of these instructions; I just bought vaccum tube from Pep Boys. I also got my supercharger used so I didn't get the CARB sticker (but living in Colorado, it hasn't been a problem). Perhaps someone can post a picture of one. I'd guess it would be easier (not cheaper) to have one made than try to find an original