It takes a bit of work, but I ran all my breathers up into the engine compartment with 1/4" fuel line then capped each one off with a fram clear fuel filter.

 

thats exactly what im thinking of doing for both front and back. run them into the engine compartment with some fuel filters on the end, that way i wont have to buy fittings?

 

My front goes up to the top of my engine compartment and the transfer case and rear diff go to the gas cap area. I have a cheapo fuel filter on the end of mine.

 

for those who put fuel filters at the end of the hose.. Am I to understand that you dont put the breather back on? You just replace that with the Fuel Filter? is that right?

 

Right, connect the hose to the diff, run the hose to higher ground, stick on a fuel filter to the end.

 

Ohh wait.. you Don't even remove the diff beather?? or replace it with that other breather part thingy? I can just add 1/4" feulline and then add the filter?
so a step by step would be like..

1) Get Fuel Line
2) Attach to Original Diff Breather.
3) Run line to someplace high? (where?)
4) Add fuel filter (any kind in mind?) model number?
thanks

 

Click on the links that Bob and Waskily posted. Those are some good instructions. Also see the tech reports section for more info.