cat removal/ cutout install
Sep 22, 2007 | 01:40 PM
#1
Thread Starter
Registered User
Joined: Jan 2007
Posts: 467
Likes: 6
From: Portland, OR
cat removal/ cutout install
i have 2001 4runner LTD with 2 cats. i plan on getting a set of headers and removing one of the cats. in the gap where the cat was i am planning on intalling a cutout with a turndown installed for offroad rumble. i was planning on doing an exhaust system but i do a lot of driving so i dont want the constant rumble. so my question is wich cat can i remove with out throwing a code and what cutout should i use? i would like the ease/ speed of a cylinoind but wouldnt mind the reliability of a manual pull cable.
THNKS for your time.
ETRNL
THNKS for your time.
ETRNL
Sep 22, 2007 | 02:08 PM
#2
Contributing Member
Joined: Jun 2004
Posts: 1,813
Likes: 0
i have 2001 4runner LTD with 2 cats. i plan on getting a set of headers and removing one of the cats. in the gap where the cat was i am planning on intalling a cutout with a turndown installed for offroad rumble. i was planning on doing an exhaust system but i do a lot of driving so i dont want the constant rumble. so my question is wich cat can i remove with out throwing a code and what cutout should i use? i would like the ease/ speed of a cylinoind but wouldnt mind the reliability of a manual pull cable.
THNKS for your time.
ETRNL
THNKS for your time.
ETRNL
neither, leave it stock.
unless you plan on getting an o2 simulator from urd.
Thread
Thread Starter
Forum
Replies
Last Post
129Creepin
86-95 Trucks & 4Runners
9
Aug 5, 2015 10:12 PM
