3.0 mods
Nov 22, 2004 | 04:00 PM
#1
Thread Starter
Registered User
Joined: Nov 2004
Posts: 1
Likes: 0
3.0 mods
I am starting to rebuild my 3.0 from an 88 4 Runner (doesn't work without oil 
) and I want to make sure I don't miss any good ideas. So if anyone has any ideas I would greatly appreciate hearing them. I know that intake and exhaust are concerns I have heard and I read a great write up on this site about Downey headers but I have also read contradictory reports on other sites. Give me all you got guys and girls. I am pretty sure I am doing a rebuild and not a swap for cost control and it sounds like I can get the 3.0 to purr pretty good.
) and I want to make sure I don't miss any good ideas. So if anyone has any ideas I would greatly appreciate hearing them. I know that intake and exhaust are concerns I have heard and I read a great write up on this site about Downey headers but I have also read contradictory reports on other sites. Give me all you got guys and girls. I am pretty sure I am doing a rebuild and not a swap for cost control and it sounds like I can get the 3.0 to purr pretty good.
Nov 22, 2004 | 07:10 PM
#2
Registered User
Joined: Feb 2003
Posts: 3,689
Likes: 4
From: Sarasota, FL
larger valves seems to help the motor a bit from word of mouth...
DOA has cams, heads, and overbored TBs....
Dan is putting 3vzfe heads (24v) on his 3vze (12v) bottom end for increased flow. Expected same bottom end torque with much higher Hp and torque as you wind up the gears....
DOA has cams, heads, and overbored TBs....
Dan is putting 3vzfe heads (24v) on his 3vze (12v) bottom end for increased flow. Expected same bottom end torque with much higher Hp and torque as you wind up the gears....
Nov 23, 2004 | 12:38 PM
#3
Registered User
Joined: May 2004
Posts: 3,291
Likes: 0
From: 100 miles offshore as much as possible, & Springfield Oregon USA
Thread
Thread Starter
Forum
Replies
Last Post
FS[SouthEast]: 1992 4Runner with 3.4 5speed $2000
sphealy
Vehicles - Trailers (Complete)
1
Sep 3, 2015 07:55 PM
