I am going to add a 2" body lift to my 4" superlift and want to know if any one here has done this to there truck? And is there any complications I am going to run into on the install because I have the 4" superlift?
Thanks
TJ

 

Shouldn't be a problem since the BL only deals with the body. Everything else should be stock height underneath like brake lines, fuel filler, ect...

 

the only thing i was worried about was the battery cables

 

I just put a 1" BL on and the only problems I had were unrelated to my Superlift. I had to loosen my steering shaft clamp to lengthen it a little and lower my transfer case shifting linkage (auto tranny). Roger Brown has some great info but I can't get his site to come up, it used to be here http://4crawler.cruiserpages.com/4x4...le/index.shtml

 

I did a 2" on my Runner and just had to reroute the battery cable a little bit to get some more length on the positive side. The neg was fine. Check the brackets for your clutch hardline too. I just moved the bracket down to the lower hole and only used one bolt to bolt it back to the firewall.

 

Here is the new address for Roger Brown's info: http://www.4crawler.com/4x4/ForSale/BodyLiftKit.shtml