Notices
The Classifieds GraveYard Where old classifieds threads go that are too good to let go

84 toyota ext cab pickup

Old Dec 29, 2006 | 10:07 PM
  #1  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
84 toyota ext cab pickup

FOR SALE
1984 EXT CAB
TOYOTA PICKUP

This truck is the one you?ve been looking for. It is a solid axle 84 ext cab 5 speed w/ 3?suspencion and 3? body lift for 6? overall lift. 32x11.5 Dunlop RV?s 50% tread on Steal wheels. 2? Headman Header, Hiflow Cat and Dynamax muffler and an in the bed roll cage. It has a Carbureted 22R motor with 184000 miles and a new timing chain other than that it?s stock. The only thing that?s wrong with it is the timing chain cover leaks oil. The PO used blue RTV instead of red and the heat has made it leak. This started out as a father/ son project that turned into a father project. My son went over to the dark side and got a lowered S10 with a 350 small block. I don?t know were I went wrong but it?s time to get out and work on my Tacoma.

Everyone says too many new parts to list. Bull S##T I?ll list them. New in the last 6 months installed.

? Starter.
? Alternator.
? Clutch/ Slave cylinder.
? Cap, Rotor, Wires and Plugs. Volt Regulator and Battery.
? Brake Master Cylinder/ Pads and new rear drums.
? Rebuilt Front Diff w/Waren hubs,Marlin knuckles, bearings and ext breathers.
? Rebuilt Carb. New Vac lines Fuel Pump PCV and BVSV.
? SR5 interior Grey. Home paint Job Black.
? 2? receiver hitch and rear bumper.
? M8000 Ramsey Winch.
? Pioneer Stereo and speakers

What I have new too install.
? Rocky mountain Teflon bushing kit

What I?ve done in the last 6 months.
? Repaired the bed w/ steal.
? Repaired the floor boards w/steal.
? Boxed the Frame w/steal

Spares that come with the truck.
? Front Diff complete excluding locking Hubs.
? Complete engine gasket set.
? SR5 Gauge cluster. I left the stock one in to show mileage.
? Steering column.
? Tail lights.
? Universal joints.
? Knuckle seal.
? Another rebuilt carb and intake.
? What?s left of the stock interior.
? Fly wheel sprocket for starter.
? Tail gate and hardware needs work. I have a net installed.
? Wiper motor.
? What ever else I can find to add.

This is a solid truck that needs a new home. I don?t consider this a toy and I will not sell it to some kid to trash. I?ve put too much time into it. This truck deserves better. I?m asking $3000 for the whole package but would consider selling the spares separately for the right buyer.
Old Dec 30, 2006 | 10:56 AM
  #2  
joeylead's Avatar
Registered User
 
Joined: Feb 2005
Posts: 45
Likes: 0
could you e-mail some pics to joeylead@hotmail.com? If I ever sell my taco, this is the type of truck I am looking for!
Old Dec 30, 2006 | 12:19 PM
  #3  
whitetaco02's Avatar
Registered User
 
Joined: Jan 2006
Posts: 449
Likes: 0
From: Georgia
can you post some pics?
Old Dec 30, 2006 | 01:50 PM
  #4  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
I'll post pic's sunday when my son is home. I'm computer challenged.
Old Dec 31, 2006 | 05:48 AM
  #5  
88rnr86up's Avatar
Registered User
 
Joined: Dec 2005
Posts: 193
Likes: 0
From: Va
I want to see the pic also get us some frame shoots any rust issues being from Pa
Old Dec 31, 2006 | 03:52 PM
  #6  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
pics









if you need more just ask.

Last edited by Pa bowhunter; Dec 31, 2006 at 04:03 PM.
Old Jan 1, 2007 | 12:42 PM
  #7  
88rnr86up's Avatar
Registered User
 
Joined: Dec 2005
Posts: 193
Likes: 0
From: Va
you have 1 of the front and rear want to see what is below the front bumper in the pics
Old Jan 1, 2007 | 02:23 PM
  #8  
shawn0890ss's Avatar
Registered User
 
Joined: Mar 2006
Posts: 171
Likes: 0
From: Lansdale, PA




need any more just ask. there on my cammra just dont feel like uploading all of them unless needed. but i could send all of them in email.

Last edited by shawn0890ss; Jan 1, 2007 at 02:25 PM.
Old Jan 2, 2007 | 01:20 PM
  #9  
88rnr86up's Avatar
Registered User
 
Joined: Dec 2005
Posts: 193
Likes: 0
From: Va
send me all you got to email in sig at bottom
Im going to be in mount carmel Pa in jan 13-16
how far from you
Old Jan 2, 2007 | 04:01 PM
  #10  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
I'll get some underside shots and have my son post them. Yes there was spots rusted on the frame from the back of the cab to the shock mounts. They were not allthe way around it looked like there were holes built into the frame that inlarged over the years. and right were the curve up to th spring mount is must have held water. I used 3/16 steel on both sides to box and added angle iron on top of that for extra support. the center cross member I reinforced and replaced the rear round cross altogether. I've undercoated it so hope you can see what you want in the pics.

I'm in SE Pa about 20 mi outside Philly. The Mount Carmel sounds familure but I don't know where it is.

mount carmel is about an hour and 45min away. its up near bloomsburg. i am located down twards philly in lansdale pa 19446. not far from the lansdale exit on 476

http://maps.google.com/maps?saddr=Mo...=UTF8&z=9&om=1

Last edited by Pa bowhunter; Jan 3, 2007 at 11:07 AM.
Old Jan 3, 2007 | 11:02 AM
  #11  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
more pics guys

frame shots.
















Old Jan 3, 2007 | 02:03 PM
  #12  
whitetaco02's Avatar
Registered User
 
Joined: Jan 2006
Posts: 449
Likes: 0
From: Georgia
i sent you a pm yesterday. did you get it? thanks
Old Jan 3, 2007 | 04:02 PM
  #13  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
Yes reply sent
Old Jan 3, 2007 | 07:20 PM
  #14  
88rnr86up's Avatar
Registered User
 
Joined: Dec 2005
Posts: 193
Likes: 0
From: Va
as of rite now is it up for a 300 mile road trip to Va how is the steering
still have rear seats and belts?

Last edited by 88rnr86up; Jan 3, 2007 at 07:32 PM.
Old Jan 3, 2007 | 08:00 PM
  #15  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
I'd do it. you'll be in the slow lane w/the stock gears and you'll want a chase car with room for some of the spares that come with it and a tool box. I won't take my tocoma to the store without my tool box. I guess you mean front seats and belts .Yes the interior is in great shape.
Old Jan 4, 2007 | 06:17 AM
  #16  
88rnr86up's Avatar
Registered User
 
Joined: Dec 2005
Posts: 193
Likes: 0
From: Va
I meant back jump seats my last 84 had jump seats but some come with out them
Old Jan 4, 2007 | 06:57 AM
  #17  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
No jump seats it has a shelf
Old Jan 15, 2007 | 05:19 PM
  #18  
shawn0890ss's Avatar
Registered User
 
Joined: Mar 2006
Posts: 171
Likes: 0
From: Lansdale, PA
still for sale people
Old Jan 25, 2007 | 09:24 AM
  #19  
Pa bowhunter's Avatar
Thread Starter
Registered User
 
Joined: Jul 2006
Posts: 33
Likes: 0
From: Lansdale, Pa 19446
Sold. The new owner is shiping it to Haitie. His daughter is a missionary there. I couldn't have asked for this truck to be used for a better purpose. Now it's on to upgradeing my Tocoma.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Regency
86-95 Trucks & 4Runners
5
Jul 5, 2015 08:16 PM
Valvoman
86-95 Trucks & 4Runners
3
Jun 28, 2015 02:45 PM
94more
86-95 Trucks & 4Runners
5
Jun 19, 2015 01:55 PM
Old Red 94
86-95 Trucks & 4Runners
3
Jun 16, 2015 08:32 PM
mytruck
95.5-2004 Tacomas & 96-2002 4Runners
25
Jul 15, 2002 04:28 AM


Thread Tools
Search this Thread

All times are GMT -8. The time now is 04:11 AM.