yup 350 with no winch, im in the chattanooga area and will drive no more than 200 miles to meet a buyer






If your interested and need more up close pics let me know and I"ll throw em up here asap

 

halfway to dallas isnt 200 miles is it?

 

last I checked it wasn't, if you can get some cheap shipping be my guest but im not messin with it. It weighs 150lbs

 

Why are you selling the bumper?

 

Any close-up pics?

What is the condition? (Paint scratches, rust, etc?)

How long have you had it?

<-- Atlanta, moderately interested.

 

DHL will ship bumpers. Workes out to be about $50 half way cross country. Probably cheaper than you meeting someone half way.

 

Why must you be on the other side of the country!!!

 

Might be interested if I could make it fit a 1st gen.

 

I would definately be interested, but I would need it shipped to NJ via DHL, little too far for me to drive, although for aday trip might not be bad.....

 

I had an 87 4runner that my dad now owns, you'd have to make mounts but I'll measure the width and depth and get back to you. Its prob too wide but I'll check.

Steve- Im in the process of building a rear bumper for the runner right now and its not as hard as I expected and its looking real good. So I figured I'd build me a front bumper next to match it.

The spoiler on the bottom has one dent on the left, there are some scratches on it and we cut the sides and rewelded them to match the smaller fender flares. Rustoleum matches the factory powder-coating almost dead on.. You cant see a difference where I've touched up.

 

Thats all I have right now, Im going to work on the rear bumper in the morning so I'll wipe the dirt off and take some more close ups. I've had the bumper since jan. of this year so any rust is just small surface rust spots in some of the scratches.

 

Does anyone know if this will fit an '04 taco? Do you have a p/n so I could research??
Thanks.

 

since he had to cut and reweld the bumper to fit the small SR5 flares, it must be the PRADO bumper. it should fit on the tacoma's, but i'm not sure what years...

 

it will fit on tacomas, let me get back to you on the years though, if it will mount to an 04 it would fit better than the original prado bar since its cut.

 

ok I just checked ARB and it says the same part number for 95-04 tacos. Then its different for 05-up. I know it will fit on a 96 taco so just let me know. Where are you located.

 

I'm in FL zip is 32955...

 

what are you going to do for the front?

 

build one, I just finished building a rear bumper and it turned out beautifully

 

LOL yes i know that you are building one. i meant whats it gonna look like??

 

haha yea I forgot about that, heres one similar to what Im gonna build. its the one on the black runner, but with just one bar in front of the grill

http://www.armorology.com