Southeast Fall Colors Run - Nov 5-7 @ Tellico
#702
Originally Posted by turboale
Just so long as everyone atleast has a tent, so they don't have to pitch their own. 



The trail head and the pay box are 12 - 15 miles from the campground
on a gravel dusty road. The last time we had this many runners SE4RJ
we met around 8:30 - 9:00 at the campground - gas at the campground as well for those that need gas. With the amount of dust on the road - it pays to have a CB - can't see what is coming
It will sort itself out Friday night
I am trying to finish my sliders this week - I hope to have them on - but maybe not Just may have to be careful - AGAIN
#704
Cb
What channel are we going to be monitoring? I can monitor from the time we leave Asheville 'till everyone gets in on Fri. night. in case anyone has a problem finding the place or has troubles.
#705
Originally Posted by seaflea
What channel are we going to be monitoring? I can monitor from the time we leave Asheville 'till everyone gets in on Fri. night. in case anyone has a problem finding the place or has troubles.
Conditions don't matter - I think there would be dust on that road in a rain storm !
Most everybody waited until we went to the Honor box before airing down.
15 PSI works very well on my 31's
Oh Yeah - bring your OWN beer ! I'll have mine !
#706
Matt is not driving his Runner, because we used a double cardan joint for his front square d-shaft and the angle makes it not want to move enough at full droop. It turned out real beefy, with plenty of slip not bad for our first attempt. We are looking for a single u-joint flange to replace the outer tube and It'll be ready to spin. He broke his steering box weld and a bolt head so he is trying to fab some plates out of 1/4" He is getting done with his spool pinion and outer axle seal today so we'll be mudding in 2wd tonight.
My d-shaft is still in peices but I am gonna use the joints from the cardan joint in matt's square shaft cause the are 28mm. If That is a pain, I'll use his rear shaft and t-case flange.
I am down for any harder trails. I have BFG 305 MTs, TJM, winch, E-locker, beefy sliders and beefy bumper. I also have a couple 25-50ft thick tow staps, snach block and a hilift. I'm not to worried about the dust cause it makes my paint look cleaner, plus I can use the snorkel for something other than swimming.
Eric has his sliders on and a new tjm so he thinks he can follow on the hard trails with bald 31" x-terrains and no tow points. Emily is gonna leave her 97 Limited w/locker in camp cause the only mod she has is no running boards.
My d-shaft is still in peices but I am gonna use the joints from the cardan joint in matt's square shaft cause the are 28mm. If That is a pain, I'll use his rear shaft and t-case flange.
I am down for any harder trails. I have BFG 305 MTs, TJM, winch, E-locker, beefy sliders and beefy bumper. I also have a couple 25-50ft thick tow staps, snach block and a hilift. I'm not to worried about the dust cause it makes my paint look cleaner, plus I can use the snorkel for something other than swimming.
Eric has his sliders on and a new tjm so he thinks he can follow on the hard trails with bald 31" x-terrains and no tow points. Emily is gonna leave her 97 Limited w/locker in camp cause the only mod she has is no running boards.
Last edited by Hyperlite; Nov 1, 2004 at 11:13 AM.
#707
Sweet, I should be getting my sliders on tonight or sometime this week. If someone could please post a list of things I need for a CB I'm going to put a rush delivery on a Cobra 75WX ST and Firestick II? Brian I might jsut get with you on AIM and get a list from you, I liked the coax cable you used.
As for food I might be able to bring all the buns, hmaburger and hot dog buns you need, my dad works for Flowers Baking Co. and might be able to get me 6-7 12pks. of each, I'll ask tonight and find out for sure.
For those with the e-locker, can someone school me real fast on the all range locker mod. Do I cut the red and blue wire in half and ground it, or do I just splice a ground wire into it and fork it off from one point?
Thanks in advance.
As for food I might be able to bring all the buns, hmaburger and hot dog buns you need, my dad works for Flowers Baking Co. and might be able to get me 6-7 12pks. of each, I'll ask tonight and find out for sure.
For those with the e-locker, can someone school me real fast on the all range locker mod. Do I cut the red and blue wire in half and ground it, or do I just splice a ground wire into it and fork it off from one point?
Thanks in advance.
#708
cut the (?) wire and ground it to the body, sorry I'm part color blind. It's real easy and you won't screw anything up.
You can get the cobra and all the accesories at a truck stop.
CB
Antenna
Coax
ss connecter
spring-opt
You can get the cobra and all the accesories at a truck stop.
CB
Antenna
Coax
ss connecter
spring-opt
#710
Originally Posted by seaflea
So, area we meeting at a certain time and place Sat. morn.? I think there was something about this earlier in this thread but I am too lazy to look it up.
Austin I think you said we would party
at the cabin and meet at Crawfords for the trail rides. Is this correct?
Austin I think you said we would party
at the cabin and meet at Crawfords for the trail rides. Is this correct?
#712
looks like we have some company
MCJ in Tellico nov. 5-7
A few jeeps from Mid-carolina jeeper are going to be in tellico for these dates.
anyone that want to run with us are welcome. we have a cabin on trail #1.
we plan on running lower 2 , slick rock and helo pad.
also will make night runs fri & sat !!
We are the Black sheep boys of the club!! so leave the kids at home
should be a good time
__________________
"HIT IT A LITTLE HARDER THIS TIME"
MCJ in Tellico nov. 5-7
A few jeeps from Mid-carolina jeeper are going to be in tellico for these dates.
anyone that want to run with us are welcome. we have a cabin on trail #1.
we plan on running lower 2 , slick rock and helo pad.
also will make night runs fri & sat !!
We are the Black sheep boys of the club!! so leave the kids at home
should be a good time
__________________
"HIT IT A LITTLE HARDER THIS TIME"
#713
Originally Posted by Doc279
Let's us channel 11 ( November - get it ? )
Conditions don't matter - I think there would be dust on that road in a rain storm !
Most everybody waited until we went to the Honor box before airing down.
15 PSI works very well on my 31's
Oh Yeah - bring your OWN beer ! I'll have mine !
Conditions don't matter - I think there would be dust on that road in a rain storm !
Most everybody waited until we went to the Honor box before airing down.
15 PSI works very well on my 31's
Oh Yeah - bring your OWN beer ! I'll have mine !

We will be monitoring that for the entire run. Unless there is a lot of traffic on it.
#715
Today the weather channel shows this forecast:
Wed
Nov 03 T-Storms 74°/53° 80 %
Thu
Nov 04 Few Showers 63°/41° 30 %
Fri
Nov 05 Partly Cloudy 58°/33° 20 %
Sat
Nov 06 Sunny 61°/42° 20 %
Sun
Nov 07 Partly Cloudy 60°/36° 20 %
Looks like the trails will be a little wet after the rain on Wednesday and maybe a freeze on Friday.
Wed
Nov 03 T-Storms 74°/53° 80 %
Thu
Nov 04 Few Showers 63°/41° 30 %
Fri
Nov 05 Partly Cloudy 58°/33° 20 %
Sat
Nov 06 Sunny 61°/42° 20 %
Sun
Nov 07 Partly Cloudy 60°/36° 20 %
Looks like the trails will be a little wet after the rain on Wednesday and maybe a freeze on Friday.
#716
Originally Posted by Doc279
I'll just drive around with you Brett - I still have to drive mine
everyday ! We can film and help
to the real runners.
everyday ! We can film and help
to the real runners.
Yep, gotta drive mine home too-and I got enough of fixing broke parts years ago when I was a drag racer-I'm all for no broken stuff nowadays.
#717
Originally Posted by seaflea
We will save you a spot!
Why so late?
Why so late?
#719
Yeah tony,
I'm really sorry to hear that... We will have a couple cold ones for you and your wife when you get there. Can't wait to get there (man i have an azz load of stuff to do before then
I'm really sorry to hear that... We will have a couple cold ones for you and your wife when you get there. Can't wait to get there (man i have an azz load of stuff to do before then
#720
Originally Posted by turboale
Yeah tony,
I'm really sorry to hear that... We will have a couple cold ones for you and your wife when you get there. Can't wait to get there (man i have an azz load of stuff to do before then
I'm really sorry to hear that... We will have a couple cold ones for you and your wife when you get there. Can't wait to get there (man i have an azz load of stuff to do before then

i still got to figure out a mounting point for my CB antenna, i don't have an aftermarket front bumper or anything, much less anywhere decent around here to get a bracket.


