I finally pulled my ARB snorkel out of the box to see how it would line up with my new fender and general restoration after the roll over. I cannot see how there is any room on the "A" pillar to attach the bracket. Perhaps the roll over squashed my cab too much but the bolt holes line up on top of the windshield trim and I would have to drill through the glass to install it.

How have people installed this snorkel bracket on their T? I bought the Taco version, which will also require some additional pipe from the airbox to the snorkel. Will black ABS pipe fit for that, or did you use some sort of flexible piping like dryer vent hose?

Looking forward to getting the T back on the road after 2 years, been way too long.