replacing rear brake line?
#1
Registered User
Thread Starter
Join Date: Mar 2008
Location: VT
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
replacing rear brake line?
i recently replaced my front calipers and brake lines, but when bleeding the front brakes my rear line blew out around the gas take area.
I wanted to just disconnect that line and run a new one from the mastercylinder to the rear porportioning (sp?) valve. or atleast thats where i think it goes.
is this somthing i can do in my driveway with a jack and jackstands and simple hand tube bender or should i send it to a shop to do? i've never bled rear brakes with drums before any info is appreciated thanks a bunch
also wondering if anyone has a diagram of the brake lines for a 95 v6 4runner? thanks
I wanted to just disconnect that line and run a new one from the mastercylinder to the rear porportioning (sp?) valve. or atleast thats where i think it goes.
is this somthing i can do in my driveway with a jack and jackstands and simple hand tube bender or should i send it to a shop to do? i've never bled rear brakes with drums before any info is appreciated thanks a bunch
also wondering if anyone has a diagram of the brake lines for a 95 v6 4runner? thanks
Last edited by nikh_713; 03-11-2008 at 06:21 PM.
#2
Registered User
Call the dealer and get their price on the prebent factory line. It probably wont be too expensive. I bought fuel line from the dealer and I was surprised that they diddnt want an arm and a leg for it.
Thread
Thread Starter
Forum
Replies
Last Post
Aleeex_u
86-95 Trucks & 4Runners
10
06-05-2016 06:52 PM
voiddweller
86-95 Trucks & 4Runners (Build-Up Section)
19
05-02-2016 09:10 PM