Hey all, so i took my newly SAS'd truck out on a drive up to Seven Springs AZ for some shooting practice and testing out how everything held up. which it held up perfect, and then my pressure plate tweeked out on me....Sooo i was wondering how long will my pressure plate last if it started going out on sunday? Also how long till the clutch, bearings, master and slaves will last if my plate is starting to go out? Thanks!!!!!

 

Could last a month, could explode in the next 30 seconds.
I'd r/r ASAP.

:wabbit2:

 

What do you mean by r/r? sorry

 

Replace/Repair

:wabbit2:

 

Alright i think i will, toyota said theyd do it for 1300-1700 bucks

 

DIY much cheaper

:wabbit2:

 

If theres anyone in arizona who would fix it for me ill pay them, but i dont trust myself doing a job that big.

 

What? ... you can do an SAS but not a PP?

Last one I did, the kit cost under $40 (ebay 5 years ago). I had local repair shop get dirty for me and did the front and rear seals while they were in there.
It was done 3 hours later and cost me $214 labor and I was rolling again that afternoon.

I usually do my own but didn't have a free weekend to do it at that time.

 

Yeah well i havnt tried it but i doubt i could get it done. Its just im worried that everything else will break along with the pressure plate so i may just spend the big bucks for everything to get fixed.

Theres a local shop ill call up but they are a rip off so ill see if their cheaper than toyota