2UZ Timing Belt Help
Nov 14, 2011 | 02:55 PM
#1
Thread Starter
Registered User
Joined: Apr 2005
Posts: 1,436
Likes: 95
From: Frederick, MD
2UZ Timing Belt Help
I have the front end of the motor torn down on an '03 and cannot get the Crank Pulley Belt off. I'm using a homemade SST to hold the crank pulley with the 2 threaded holes but can't get the bolt to budge.
Suggestions?
Suggestions?
Nov 14, 2011 | 03:32 PM
#2
Contributing Member
Joined: Nov 2010
Posts: 5,125
Likes: 4
From: Columbia River Gorge, Oregon...east side
Get a buddy/SO to hold the SST while you pull on the breaker bar. Also, soak the bolt with PB Blaster. Sometimes, gentle tapping on the flange around the bolt with a hammer and blunt punch will help break the rust loose.
Last edited by rworegon; Nov 14, 2011 at 03:34 PM.
Nov 14, 2011 | 04:07 PM
#4
Contributing Member
Joined: Nov 2010
Posts: 5,125
Likes: 4
From: Columbia River Gorge, Oregon...east side
Probably not, but I've not have this engine apart. There may be a thread around here that answers that question.
Added info: After looking at a few 2UZ TB threads, no one mentioned reverse threaded Crank bolt.
Sometimes trying to tighten (clockwise, righty) a bit will actually help the loosening (counter-clockwise, lefty).
Added info: After looking at a few 2UZ TB threads, no one mentioned reverse threaded Crank bolt.
Sometimes trying to tighten (clockwise, righty) a bit will actually help the loosening (counter-clockwise, lefty).
Last edited by rworegon; Nov 14, 2011 at 04:17 PM.
Nov 14, 2011 | 04:49 PM
#5
Contributing Member
Joined: Dec 2008
Posts: 2,505
Likes: 16
From: San Jose ,Ca
here you go man ..
https://www.yotatech.com/forums/f28/...cement-163431/
https://www.yotatech.com/forums/f28/...cement-163431/
Thread
Thread Starter
Forum
Replies
Last Post
