Stamping On The Igniter
Jan 18, 2012 | 10:41 AM
#1
Thread Starter
Registered User
Joined: Jan 2012
Posts: 16
Likes: 0
Stamping On The Igniter
I switched from the 94 Igniter with the stamping of 208 to a 90 Igniter Coil and Igniter with the stamping 147. It is not firing. Does anybody know if the ECM reads from the original igniter and cause a no spark condition.
Jan 18, 2012 | 01:19 PM
#3
Registered User
Joined: Mar 2008
Posts: 12,723
Likes: 6
From: Temecula Valley, CA
Igniters change over the years.
When you go to start, the igniter handles firing the spark plugs itself, with no feedback from the ECU. Once the engine starts, the igniter hands control of timing over to the ECU. It's possible different ECU's handle igniters differently.
I would think that igniters with different part numbers don't work the same.
When you go to start, the igniter handles firing the spark plugs itself, with no feedback from the ECU. Once the engine starts, the igniter hands control of timing over to the ECU. It's possible different ECU's handle igniters differently.
I would think that igniters with different part numbers don't work the same.
Thread
Thread Starter
Forum
Replies
Last Post
zombie_barbarossa
95.5-2004 Tacomas & 96-2002 4Runners
3
Oct 2, 2015 10:54 PM
