slip yoke, interchangeable?
Oct 9, 2011 | 05:44 PM
#1
Thread Starter
Registered User
Joined: Sep 2010
Posts: 137
Likes: 0
slip yoke, interchangeable?
I bent the flange beating out an old U joint. Found a used slip yoke, still attached to the flange, on ebay. The ujoint on this used part is still good. To save me some time, can I just slide this new slip yoke into my existing driveshaft and bolt on? or is that a bad idea?
Oct 12, 2011 | 10:46 AM
#3
Registered User
Joined: Oct 2009
Posts: 4,832
Likes: 332
From: Northfield, Vermont
Oct 12, 2011 | 04:05 PM
#4
Registered User
Joined: Jan 2007
Posts: 6,106
Likes: 27
It may or may not have the exact same u-joint(same size, but possibly different slightly in design internally as far as bearing size and/or greaseable vs. non) . But I'm pretty sure all 86-95 trucks and 4Runner driveshafts use the same slip yokes, size and spline count wise. Even 2WD, I believe.
Thread
Thread Starter
Forum
Replies
Last Post
justdifferentials
Just Differentials
5
Jun 13, 2022 07:40 PM
justdifferentials
Vendors Build-Ups (Build-Up Section)
14
Jun 11, 2017 08:36 PM
icentropy
86-95 Trucks & 4Runners
7
Sep 10, 2015 05:03 AM
