Post Your Pics!!!
The following 2 users liked this post by atlantarocket:
RAD4Runner (01-04-2022),
SomedayJ (01-04-2022)
The following 2 users liked this post by rattlewagon:
SomedayJ (01-14-2022),
swampedout (01-14-2022)
Custom cab!
Registered User
Had to post a couple pics of the last year's progress.
Day 1
Ball joints 🖕
Valve covers
Timing belt etc.
First trail! Peters Mill run, VA
Assateague Isl., MD
Fuel pump
Softtopper!
Most recent pic, needs a bath
Thus far major items I've replaced include (in no particular order):
- upper & lower ball joints
- Pitman and idler arm
- All 4 shocks
- Rear leafs, shackles, bushings
- Fuel pump, hanger bracket, filter, and line from tank to engine
- Front brakes and wheel bearings
- Pass. Front brake caliper (seized)
- Brake line from pass. Front to lspv
- Brake line from rear diff junction to driver's rear drum
- Brake master cylinder & booster
- Valve cover gaskets
- Timing belt, water pump etc
- all 3 accessory belts
- Fan clutch
- Radiator
- Ac tensioner pulley (missing when bought)
- O2 sensor
- Ignition coil
- 5 tires (had original spare )
- inner tie rods
- Rear trunk interior trim covers (missing when bought)
- transfer case output shaft seal
- Rear floor heater heater hoses
- replaced all vacuum lines
- Throttle position sensor
- Coolant temp sensor
- Tune up kit (plugs, wires, cap, etc)
- pair of wolf steel rear wheelhouse replacement panels (not installed)
been a busy year and haven't even gotten to the bodywork yet lol
previous owner didn't do ˟˟˟˟ on this thing, but that's what I get for impulse buying a suspiciously cheap 4runner on ebay sight unseen lol. Canceled my Bronco reservation for this instead and have been loving it! Wouldn't trade it for anything.
Last edited by 884RunnerSR5; 01-18-2022 at 06:47 PM.
The following 3 users liked this post by 884RunnerSR5:
The following 7 users liked this post by jaskotmb:
884RunnerSR5 (01-29-2022),
old87yota (01-27-2022),
RAD4Runner (01-27-2022),
skill619 (07-31-2023),
SomedayJ (01-27-2022),
and 2 others liked this post.
The following users liked this post:
SomedayJ (02-12-2022)
My New 1992 V6 5spd as of August 2021. Before and After.
3rd Owner, very little rust but lots of cleaning to do!
3" 4crawler body lift, Marlin tube bumper, oem wheels on 33"x9.5 Superswampers. 4.88 re-gear with rear spartan locker, manual locking hub conversion.
3rd Owner, very little rust but lots of cleaning to do!
3" 4crawler body lift, Marlin tube bumper, oem wheels on 33"x9.5 Superswampers. 4.88 re-gear with rear spartan locker, manual locking hub conversion.
The following users liked this post:
SomedayJ (02-13-2022)
Registered User
Bummer!
Do you know if the frame is damaged?
Do you know if the frame is damaged?
Registered User
92 project truck
Bought this from an old friend for a winter project. Po said he was tired of putting money into it and hadn't run in 2 years. Trailered it home and had it running in a couple hours. Didn't run good but it had a pulse, and quickly turned into my daily driver.
The following 5 users liked this post by Steky:
Nervo19 (03-23-2022),
old87yota (03-25-2022),
RAD4Runner (03-25-2022),
skill619 (07-31-2023),
SomedayJ (03-23-2022)
The following users liked this post:
RAD4Runner (03-25-2022)
The following 3 users liked this post by SomedayJ:
The following users liked this post:
RAD4Runner (03-31-2022)
The following 5 users liked this post by joeynational:
84 yota dude (04-07-2022),
MooseRunner (11-30-2022),
skill619 (07-31-2023),
SomedayJ (04-11-2022),
ztbailey1 (03-31-2023)