Oil pressure sensor connector
#1
Registered User
Thread Starter
Oil pressure sensor connector
Well after almost 30 years the wire broke at the connector, had a good run. Looking to replace the connector with a pigtail. Using my googlefoo I'm coming up with 90980-11363 for a 94 xcab 4x4 3vze. Does this sound about right for those that have replaced one.
#2
Registered User
Yes, that should be the correct one for a 94 3.0L 3VZE.
Toyota used a different style up until 92/93. It looked like this: https://www.yotashop.com/sending-uni...3-83520-35032/
If your sending unit is like the one in that photo from Yotashop, any male/female single-pin connector will work.
Toyota used a different style up until 92/93. It looked like this: https://www.yotashop.com/sending-uni...3-83520-35032/
If your sending unit is like the one in that photo from Yotashop, any male/female single-pin connector will work.
#4
Registered User
Thread Starter
I actually got lucky looking thru some old connector pins i had and found a pin and seal. Depinned the old one, crimped the new one + seal and reinstalled. Up and working again. Thought for sure the connector would crumble after all these years but all good 👍
My connector is like the one JoeS posted.
My connector is like the one JoeS posted.
Last edited by Andy A; 08-30-2022 at 02:19 PM.
The following users liked this post:
old87yota (08-30-2022)
Thread
Thread Starter
Forum
Replies
Last Post