Hi. I have a 1995 4runner. I'm trying to wire my computerized keyless start/run system. I need help and lost, the wiring diagrams I have read are confusing and I seem to be missing information. So far I read this page that explains some info about the switch wiring
(from this link: http://tacoma.site40.net/4Runner_90-...es/repair.html):



On next page I get the key-in pins:



The repair manual fails to explain what pin #1, is. I know if I short pins 2 & 3, it trigger accessories on so I can assume either pin 2 or 3 is the accessory trigger and the other is a +12v power supply from an unknown source in the fusebox.
I was looking for is an exact break down of what pins 1-8 on that ignition switch harness actually do. Is there a pin-out definition page somewhere I missed when I was sorting through?

 

Ok nevermind, I finally found the right link for the factory manual I can download :

http://web.archive.org/web/201101022...ttora.com/FSM/